Dahle ShredMATIC 150 Mode D'emploi page 7

1
en Instructions
IMPORTANT!
Read the operating and safety instructions
BEFORE placing the document shredder into
operation.
You must follow the instructions.
Keep the operating instructions in a safe
place ready for later use.
Table of Contents
1 Important information . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
1.1 Intended use,
warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
1.2 Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
1.3 Key to pictograms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
1.4 Scope of supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 88
1.5 Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .88
2 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 89
2.2 Connecting the device to the power supply . . . . . 89
2.3 Switching on the device . . . . . . . . . . . . . . . . . . . . . . . . 89
2.4 Paper shredding . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90
2.10 Continuous operation . . . . . . . . . . . . . . . . . . . . . . . . . . .92
2.11 Card shredding . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93
3 Maintenance/troubleshooting . . . . . . . . . . . . . . . . . .94
3.1 Empty shredded waste . . . . . . . . . . . . . . . . . . . . . . . . . .94
3.3 Container/cover open . . . . . . . . . . . . . . . . . . . . . . . . . . .94
3.4 Overheating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .95
3.5 Paper jam, manual intake . . . . . . . . . . . . . . . . . . . . . . .95
3.7 Paper jam, automatic intake . . . . . . . . . . . . . . . . . . . . .96
3.10 Cleaning the device . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 97
1.1 Intended use, warranty
The document shredder is intended to be used for
shredding paper.
Depending on the model variant, a small amount of the
following materials can also be shredded:
- CDs/DVDs, bank cards and credit cards (see technical
data).
- The normal staples and paper clips found in paper
documents (exception: security level P6 and P7 devic-
es).
The device has an automatic intake for paper stacks that
consist of individual sheets that are not folded (max.
100 g/m²). Paper clipped together, either with paper
clips or staples, can generally also be processed in the
stacks. The precondition for this that the clips should be
on the rear side of the paper tray (pointing away from
the user).
However, removing the office clips/staples before shred-
ding is recommended to extend the life of the device. In
individual cases, depending on the quantity and posi-
tion of the clips and the thickness of the clipped stack,
misfeeding and hence an interruption of the shredding
process may occur.
Wear, damage due to improper use or unauthorised
modifications and repairs are not covered by the war-
ranty or the guarantee.
The document shredder was designed for private use
and for use in normal office environments.
The following conditions apply to the performance in
terms of sheets listed under technical data:
Maximum number of sheets that are shredded in one
pass under the following conditions: New cutting roll-
ers, oiled if needed, cold motor, power supply with
nominal voltage and nominal frequency (230 V/50 Hz;
120 V/60 Hz).
Deviations may result in reduced sheet processing and
increased operating noises. The sheets are fed centrally
and lengthwise at a 90 degree angle. The performance
in terms of sheets can also vary depending on the paper
properties and input.
7