Cleanup - Campbell Hausfeld 1 HP Instructions D'utilisation Et De Montage

Operating Instructions and Assembly Instructions
Airless Paint Sprayers

Cleanup

CLEANUP FOR OVERNIGHT STORAGE
NOTE: Cleaning and maintenance of
the pump are the most important steps
you can take to ensure proper
operation and a long life for your
airless paint sprayer. Please follow the
cleaning instructions carefully and . . .
WEAR ALL NECESSARY
SAFETY GEAR
NECESSARY TOOLS / MATERIALS:
• Two (2) buckets
• Solvent
• Plastic wrap
When reusing the
NOTICE
sprayer with the
SAME PAINT the next day at the SAME
JOB SITE, it is not necessary to flush
the paint from the system. However, IT
IS IMPORTANT TO KEEP AIR FROM
COMING INTO CONTACT WITH THE
PAINT.
NOTE: Do NOT disconnect any hoses.
1. Turn prime/spray control to PRIME
position.
High pressure hose
CAUTION
!
may still be
pres surized with prime/spray control in
the PRIME position. With the gun
pointed in a safe direction, pull the
gun trigger to relieve any pressure in
the hose.
2. Engage gun trigger lock.
3. Place spray gun in bucket of
appropriate solvent. There should
be enough solvent to COVER spray
tip. This will prevent paint from
drying or clogging tip.
4. Leave suction and bypass tubes in
bucket of paint. Make sure ends of
suction and bypass tubes are
BELOW surface of paint in bucket.
5. Cover bucket and tubes with plastic
wrap or a damp towel to prevent
film forming on paint. Or, if using
latex paint, pour a very thin layer of
water over top of paint. Stir water
into paint the next morning.
1
Turn Prime/Spray
Control to PRIME
Position
3
SOLVENT
Place Gun in
Solvent
5
PAINT
Cover Bucket
7
2
Engage Trigger Lock
4
Suction and Bypass Tubes
Remain in Bucket with Ends
Below Paint Surface
or
PAINT
Latex Paint: Use Thin Layer of
Water to Cover Paint
www.chpower.com