Publicité
Les langues disponibles
Les langues disponibles
o
peration
Sharp Blade/Wire Hazard.
Blade/Wires are sharp and can cause cuts. To avoid
injury from sharp blades/wires, handle with caution.
Prior to first use, it is important to clean the unit. Wash new unit with warm
soapy water and rinse thoroughly to remove the thin protective oil film.
1. Place the unit on a clean, flat work surface.
2. Before each use, check that the unit is clean and the cutting wire (E) is
in good condition. If loose or broken, the cutting wire must be replaced.
See Figure 1.
3. Prepare the food product to be processed.
4. Lift the cutting bow assembly (A) and place the food product on base
assembly (C) and against the front plate (D).
5. Using a slow, consistent movement draw the cutting wire (E) through the
food product.
6. Repeat this process until you have prepared enough food product for
your daily needs.
7. Clean and lubricate your machine immediately after each use. See the
CLEANING section of this manual for more information.
C
leaning
Sharp Blade/Wire Hazard.
Blades are sharp and can cause cuts. To avoid
injury from sharp blades, handle with caution.
To maintain the appearance and increase the service life, clean your daily.
NOTE:
Food acids will make blades dull and corrode the metal.
Always clean this food preparation machine immediately
after every use.
1. Remove the thumb screws (I) and front plate (D) from the base
assembly (C).
2. Wipe, rinse or spray off the base assembly (C), cutting bow assembly (A)
and front plate (D) thoroughly with HOT water.
3. Do not put this machine in a dishwasher or dish machine with soaps,
detergents, or other alkaline chemicals that can harm the machine.
4. After cleaning, let the machine air dry.
5. Install the front plate (D) and securing with the thumb screws (I).
WARNING
WARNING
M
F
P
anual
ood
rocessing
p
m
reventative
aintenanCe
1. Clean machine after every use.
2. Use for intended purposes only.
3. Change blade/wire regularly - based on usage.
r
C
W
a
eplaCing
utting
ire
ssembly
Sharp Blade/Wire Hazard.
Blades are sharp and can cause cuts. To avoid
injury from sharp blades, handle with caution.
Wash new cutting wire with warm, soapy water and rinse thoroughly to
remove the thin protective oil film.
1. Loosen the wing nuts (H) holding the eye bolt (F) and the "l" bolt (G). It is
not necessary to remove the bolts or wing nuts to replace the cutting wire
(E). See Figure 1.
2. Remove and discard the old cutting wire (E).
3. Place the loops of the new cutting wire (E) onto the eye bolt (F) and the
"l" bolt (G).
4. Tighten the wing nuts (H) and the cutting wire (E).
r
p
l
eplaCement
arts
ist
See Figure 1.
LETTER
PART NO.
E
1838
F
1839
H
1840
G
1841
Not Shown
1824
e
quiPMent
WARNING
DESCRIPTION
Cutting Wire (package of 3)
Eye Bolt (package of 4)
Wing Nut (package of 6)
"L" Bolt (package of 4)
Brush
O
'
M
peratOr
s
anual
3
Publicité
