Attaching The Cover - Sony WAHT-SD1 Mode D'emploi

About the surround amplifier
After connecting, you can attach the cover to the
surround amplifier for organizing and storing
excess speaker cords.

Attaching the cover

1
Attach the speaker cord cover by
sliding it down along the grooves at the
edges of the surround amplifier.
Surround amplifier
Push the speaker cord cover down until you
hear a click. Turn the surround amplifier
upside down, then store the cords in the
speaker cord cover.
2
Insert the tabs of the speaker cord
holder in the slots of the speaker cord
cover, and press it into place.
Surround amplifier
6
GB
Speaker cord cover
Grooves
Speaker cord holder
Tabs
3
Secure the speaker cord holder with
the supplied screw.
Screw
Note
• Do not use the speaker cord cover and holder without
the supplied screw.
• Before detaching the speaker cord cover, first remove
the screw, then the speaker cord holder. Forcing the
speaker cord cover off with the screw in place may
cause damage.
• Gently pull apart the side of the speaker cord cover
when detaching.