Well Health WH-OX01 Manuel D'utilisation page 5

Section 3 Installation, Setup, and Operation
3.1 Description of the Front Panel
(as figure 3.1.1)
Figure 3.1.1 Parts of front&back panel
Item Name Description
Power Turn on the machine, direction
1
button change and Parameter settings
OLED Display the SP02/PR
2
Panel data&Plethysmogram
Table 3.1.1 Part Definition and Description
3.2 Display
After switch on, the OLED display of the Oximeter is
as follow
Battery indicator
Hemoglobin
Saturation
Plethysmogram
3.3 Parameter setting:
Press the power button (> 0.5s), the oximeter will
enter into parameter setting.
There are two submenu for choice:
When the '*' signal is shown on the 'Sounds setup',
press the button (>0.5) and enter into the sounds
setting menu (figure 3.3.1), you can press the button
in turn to select the item, and press the button to
change the data you need.
Power
Pulsa Rate
When the '*', signal is shown on the 'Aim Setup', press
the button (> 0.5s) and enter into the alarm setting
menu (Figure 3.3.2). Press the button to set the on/
off for the alarm and beep.
When the '*' signal is shown on the 'Restore', press
the button (> 0.5s) and all the settings are back to the
factory settings.
Figure 3.3.1
3.4 Operation
3.4.1 Install battery
Installing two AAA batteries into battery cassette in
correct polarities and cover it.
WARNING: Do not attempt to recharge normal
alkaline batteries, they may leak and may cause a fire
or even explode.
3.4.2 Turn the Pulse Oximeter on/off
Open the Oximeter by pressing the back part
together, insert one finger in the Oximeter (ideally up
to the end) and close it by releasing the back part.
Press power button to turn the Pulse Oximeter on.
The oximeter will automatically be powered off when
no finger in the device for longer than 16 seconds.
EN - 4
English
Figure 3.3.2