Wheel Demounting - TECO 36 Special Manuel D'utilisation

EN
20
20a

9.5. WHEEL DEMOUNTING

9.5.a MOUNTING HEAD QUICK CHANGE DEVICE
The patented system integrated inside the hexagonal vertical arm which allows changing
mounting heads in seconds without reducing the original machine working capacity
(370 mm).
To change the head, loosen the mounting head hexagonal locking screw (Fig. 21) using
the standard
supplied short wrench, pull the head down, mount the other head and tighten the hexagonal
screw using the standard supplied wrench. For a correct functioning of the device, take care
there are no plays between head and hexagonal bar.
B
21a
21
User's manual 95