Operation - Fakir Handy L Mode D'emploi

The Fakir fan heater Handy L is suitable for use as a portable heater in
living rooms. It is plugged into a socket with 230V / 50Hz AC.
Operating
• Unwind the mains connection lead and plug it into the socket.
• Turn the thermostat control (A) to the right (clockwise).
• Switch on the unit at the rotary switch (C), the pilot light (B) comes on.
Turn the rotary switch (C) to the required stage:
stage 0 = OFF
stage = fan (turn the room thermostat control all the way right)
stage 1 = heating 1000 watt
stage 2 = heating 2000 watt
During setting of the switch to the above stages, the pilot light comes on. The heater and
the pilot light are switched off in the "0" position.
Room thermostat
The temperature can be adjusted to any setting using the room thermostat control (A).
Setting: max. temperature
min. temperature
• Turn the thermostat control all the way to the right (clockwise).
• When the room is at the temperature you find agreeable, turn the control to the left
(counterclockwise) heater the unit cuts out.
• When the room temperature drops, the heaer will switch back on automatically.
∗ ∗
Frost guard setting
Turn the thermostat control (A) to the frost guard setting so that the room temperature will
not drop below approx. +5°C (for instance when absent for an extended period). The
appliance will then automatically switch itself on at approx. +5°C, and off at +7°C, there-
by preventing frost damage.
Overheat safety cut-out
An overheat safety cut-out turns off the appliance in the event of a technical fault or if the
heater is not being used properly.
If the cut-out has been activated, then turn the selector switch knob (C) to the "0" setting,
disconnect the heater from the mains, and remedy the fault or ensure that the heater is
being properly used.
The overheat safety cut-out is reactivated after a short cooling down period, and the hea-
ter can once again be operated.
NOTE: The outflowing air must not be obstructed by any object.
After use
• Switch off hte appliance and disconnect the plug from the mains socket.
All manuals and user guides at all-guides.com

Operation

= turn to the right (clockwise)
= turn to the left (counterclockwise)
11