Nostalgia Electrics IGLOO Instructions Et Recettes page 13

4. Reattach drip tray.
Cleaning Water Tanks
Cleaning the water tanks is recommended to happen once every three months.
NOTE: Recommended to do before loading a new 3 or 5 gallon jug.
1. Unplug power cord from outlet.
2. Remove water cooler bottle.
3. For hot and cold water dispensers, twist the bottle receptacle
of the smart device counterclockwise and pull it up.
4. Take apart the non-spill system and
hand wash it with warm, soapy
water. Rinse and reassemble.
5. Empty both tanks (hot and cold)
by unplugging the drain cap of the
hot tank at the back of the unit.
6. Clean the inside parts of the water
dispenser system, using vinegar or
a 2% citric acid solution to remove
mineral scaling caused by the water.
7. Rinse well, then open the drain cap for
the hot water tank to get the water out.
8. Put all the parts back and securely
fasten the drain cap.
9. Let the unit dry for two hours before
plugging it back in and install the bottle receptacle (smart device).
Cleaning Ice Maker
• Remove the ice and water separator and ice storing plate by
unscrewing the screw with a screwdriver (not included).
• Wash inside parts of ice-making chamber with warm, soapy water.
• Rinse and open the drain cap to drain all water. Rinse it several times.
• Securely fasten the drain camp and after it's dry, install them
back to original position with screwdriver (not included).
11
Smart Device
Smart Core
Water Separator
of cold tank
Cold tank