Nostalgia Electrics IGLOO Instructions Et Recettes page 10

bottle until it's secure and bottle is seated.
Plug the cord into a properly grounded wall outlet. WARNING:
3.
Always make sure that the cord is away from a water source.
DISPENSING COLD WATER
1. Press the cold water button on the panel to start making the
cold water. After this, the cold water indicator light will start to
blink, meaning the compressor has started to cool the water.
2. When light changes from blinking to staying on, cold water has
reached its desired temperature and you can start dispensing.
3. Place bottle, glass, or pitcher below the cold water tap.
4. Push the cold water dispenser to start dispensing water.
5. Release the button once desired fill level is achieved.
NOTE: After some while or after you drain out the cold water from the cold
water faucet, the Cold Water indicator will blink again, meaning it's cooling
again. Cold Water function and Ice-making function can work together.
DISPENSING ROOM TEMPERATURE WATER
1. Place bottle, glass, or pitcher below the room temperature water tap.
2. Push the room temperature water dispenser forward to start dispensing water.
3. Release the button once the desired fill level is achieved.
DISPENSING HOT WATER
1. Press the hot water button on the control panel and the green hot water indicator
light will start to blink, meaning the heating element is starting to work.
2. When the green light stops blinking and stays green, hot water has
reached the desired temperature and you can now dispense.
3. Place bottle, glass, pitcher, pot below the hot water tap.
4. Release child-safety lock by turning it counter-clockwise while pushing in.
Proceed to push the hot water dispenser to start dispensing water.
5. Release from the dispenser and release the button once desired fill level is achieved.
NOTE: If there is no water in the hot tank in the first time using or after you drain out
all of the water from the unit, after some minutes, the warning sound will alarm 10
times, and the Warning indicator will illuminate. If you place the water bottle again
and need hot water, press the Hot Water button again, the heating element will start
working again. And the Warning indicator will turn off at once. If you do not want the
hot water drink, please press the Hot Water button once more, it will save the electricity
and reduce the electricity cost. (After this, the Hot Water indicator will be off ).
WARNING: Be careful when dispensing hot water as temperature can reach 200 °F.
ICE MAKER
1. Press the Ice Maker button on the operation panel to begin the ice
making cycle. The Ice Maker indicator light will start to blink.
2. The ice making cycle lasts 7 to 15 minutes, depending on the ambient room temperature.
3. While the ice-maker is on, the unit will verify water level periodically. If there is no enough
water to make ice, the ice maker will stop automatically, and the warning indicator will
be on, meaning that the water level can not reach the requirement level for ice making.
8