Packing And Transport - Benassi AF200SL Livret D'utilisation Et D'entretien

3. PACKING AND TRANSPORT

Dimensions of the packing:
WIDTH: 76 cm
LENGHT: 80,5 cm
HEIGHT: 71 cm
⇒ Remove the leaf-sucker from its packing.
⇒ Fix the handles to the handlebar support using the screws and knobs pre-mounted on the handle.
Make sure to position the control cables correctly.
⇒ Install the plastic suction opening as shown in picture nr.5 by putting it in both bottom plates of the
central body and screw the knob as shown in picture 3 ref."P".
⇒ Install the upper plate pipe as shown in picture 4 by screwing the 4 screws ref."Q" in their slots.
⇒ Install the rotating support for the collecting bag shown by the arrow in picture 4 by screwing down
both screws to the engine support in order to fix the bent brackets.
⇒ Install the vac-bag by fixing both strips with eyelet of the upper part of the bag on the two screws
located on the upper handlebar, so that the strip covers the handlebar pipe from the outside.
Thread the bag opening on the extension of the central body and lace through the strip set in the
bag opening.
THE PACKED MACHINE IS SUPPLIED WITH THE ENGINE WITHOUT OIL AND PETROL.
⇒ It is possible to reduce the overall dimensions of the machine for an easy transport by taking away
the bag, and folding the upper handlebar on the engine after unfastening the two upper knobs,
taking off the screws and unfastening both lower knobs. See pic. 5
26
IMPORTANT
AF200SL