Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE FENCE
The energizer is preferably installed in a protected place in or at the house. However, it should not be a
fire hazard area.
There are two small loops on the top of the Ellofence M15/M30 (there are two holes on the Ellofence
M15, M60, M100, M300 and M500 housings). Here you can hang the device and attach it to two
screws or nails that you have previously mounted on a wall. The device should be mounted vertically
and not directly close to the ground.
Simply attach with two screws or nails.
In no case should it get wet or be installed in damp places at and in the
house.
If you don't have a wall nearby, you'll need to provide a suitable mount. Theoretically, you could also
hang the device on a pole, but even then the device must be protected from moisture and an outlet
must be nearby.
Now the device can be grounded, see
Now connect the red cable to the red connection of the device, which you can later connect to the elec-
tric fence tape/twine using the clamp after the electric fence has been set up.
Notice:
If there is no 230V socket on site, we recom-
mend using a 12V battery device. However, even
a 12V battery device that is installed directly on
the fence must be protected from moisture. We
would be happy to advise you on this.
IMPORTANT INSTRUCTIONS
The device must not be opened.
Possible repairs may only be carried out by qualified personnel.
"THE CORRECT
GROUNDING".
Bajonett
2
en
9
Publicité
