Acqua Brevetti MiniDOS PM008 Manuel D'usage Et Entretien page 24

A1.4 Dealers and Technical Service Centers (TSC) authorized by Acqua
Brevetti Srl
Service interventions on the equipment can be performed only by the Technical Service Centers
(TSC) authorized by Acqua Brevetti SRL. Please visit the website www.acquabrevetti.it for the list of
authorized TSC closer to you. For more information regarding the TSC, please call Acqua Brevetti
SRL (+39.049.8973432) or send an e-mail (info@acquabrevetti.it).
A1.5 Operation
MiniDOS is a self priming pump, drawing water from a tap primes the pump which doesn't require
electrical power supply; the operation is automatically activated by the water flow. Dosage of
®
AcquaSIL 20/40 is proportional to water flow for withdrawals between the minimum and peak flow
rates (see paragraph A1.7). In case of flow rates below the minimum the pump does not operate; in
case of flow rates exceeding the peak value the concentration of AcquaSIL 20/40
reduced. Therefore, the overdosage of AcquaSIL 20/40
®
20/40 in the tank is not signaled by any automatic device but it is visible from the tank level. Check
it periodically. When the level drops below the minimum please refill the tank. Dry running may cause
a temporary blockage of the pump (see paragraph A3) and lack of protection against scale and
corrosion.
A1.6 What's AcquaSIL 20/40®
®
AcquaSIL 20/40 is a ready-to-use (do not dilute) aqueous solution of food grade sodium
polyphosphate E452(i) which prevents scale and corrosion.
Anti-scaling effect: interference with scale crystallization hindering the formation of deposits.
Anti-corrosive effect: formation of a protective layer on metal surfaces which does not interfere with
heat exchange but it is effective in protecting from corrosion.
®
AcquaSIL 20/40 is available in 250 g disposable bags packaged in packs of 4 bags (cod. PC200)
or in 1 kg bottles (cod. PC002).
Keep AcquaSIL 20/40
ranging from 5°C and 35 °C. Keep out of the reach of children. AcquaSIL 20/40
dangerous according to current legislation. For any further information about AcquaSIL 20/40
please read the Information Safety Data Sheet and the Technical data sheet. Ask for these
documents to Acqua Brevetti Srl or visit the website www.acquabrevetti.eu.
A1.7 MiniDOS performances and technical datasheet
MiniDOS
Connections
Minimum flow rate
Peak flow rate
Water hardness, min-max
Max instantaneous heating temperature
Max accumulation temperature
Bag volume – refill autonomy
Tank volume – refill autonomy
Water pressure, min-max
Water temperature inside MiniDOS, min-max
MiniDOS - ENGLISH
®
in a clean place, away from direct sun and heat sources, room temperature
MAN127
®
is not possible. Low levels of AcquaSIL
Units PM008
inch ½"M
l/min 3
3
m /h 0,18
l/min 16,6
3
m /h 1
°f
°C
3 3
cm – m
bar
°C
E-23
®
in water is
®
is not classified as
PM009 PM018 PM020
½"M
½"F
BRASS BRASS
3,16
0,19
13,3 20
0,8 1,2
5 – 35
80
60
250 – 11
300 - 13
1,5 – 6
5 - 30
®
½"F