Teien 42369 Mode D'emploi page 17

1).as a sludge suction unit
-place it at a minimum distance of 1.5m from water
-ensure a safe and stable position.Keep that the drain opening is above the water
level.
-Plug the drain hose into drain opening of the collection container.
-Plug the discharge hose into the drain valve outlet of the vac drum.
-Make sure drainage valve outlet is above the water level.
-ensure that the hose lies straight,Avoid kink or bends caused by unevenness ground.
-Switch to position II
-Use vac to remove debris
-It will vacuum until the unit is full and then stops while it automatically drains
through the discharge hose and then restarts (auto cycle)
Attention:*Never operate it without foam filter and float body.(equip in factory)
*For vacuum much water,pls do not use the cloth filter,but with foam filter.
as a dry vacuum cleaner
2)
-Release drum clamps, lift off lid and insert the wet and dry filter
bag into the top of the unit.
-Lock down lid with clamps.
-Remove drainage hose and fit drain valve lid to drainage valve outlet.
-Attach suction extension tubes and desired accessory.
-Switch to position I and vacuum debris until drum is full.
-place it at a minimum distance of 1.5m from water
-seal the drain opening of the collection container by means of the plug.
Attention:*Never operate it without Cloth filter,foam filter and float body.(equip in
factory)
start-up
3)
Connect the unit to power supply.The unit is equipped with a power switch.
Position 0 Switch off
Position I Continuous dry vacuum use.
Position II Auto cycle mode, pond vacuum use.