Publicité
Les langues disponibles
Les langues disponibles
GB
Technical Specifications
360° horizontal high efficiency illumination, controlled by photocell
•
Progressive lighting and cut-off according to ambient brightness
•
ATROSPOT visibility on water of up to 700m in darkness
•
Adjustable turn-on LED illumination by trimmer
•
Can be casted out with a 3 lbs
•
Available in the following LED colors: orange, blue, red, yellow,green
•
Over one week life at a maximum light power
•
Manufactured of schock and UV resistant moulded plastic
•
Fully waterproof with EPDM o-ring & screw mechanism
•
Can be used combined with the pole « Atrotube »
•
Weight with batteries about 65g, and about 85g (balanced blue model)
•
Dimensions 128/142mm x 48mm,
•
Operating Températures –20° C à +60° C
•
3 years guarantee for normal operating conditions *
•
This guarantee excludes the enclosed foam parts, the rubbers for batteries fixing and the dart flight.
•
Mounting Instructions
Carrefully screw off the upper part of the marker.
•
Install one PP3 type battery (balanced blue) or two LR03 in the battery holder. please control polarity.
•
Fix firmly the two LR03 batteries with the aid of the two enclosed rubbers by tying them around (x3) the
•
batteries holder about 1cm at both ends .
Switch the marker on (ON or M position).
•
With the aid of a small screwdriver you can decrease or increase LED illumination by turning on trimmer (-
•
to +) . This setting process needs to be done in darkness.
Now screw the upper part back onto the marker body. Make sure that EPDM o-ring works properly.
•
The use of the enclosed foam ring (100mm white or orange) is optional.
•
In case you don't intend to use your marker for a while please remove the batteries.
•
In case water accidentally enters the marker's body, screw off its top section then take the batteries out
•
and let the different parts dry out.
•
Don't forget to grease regularly EPDM o-ring with silicone oil or vaseline
•
Further instructions for the use of your marker
To the stainless steel split ring on the marker you can attach a swivel or directly tie on your mainline for plumbing
purposes.
NB : The use of a swivel avoids line twist during the retrieval of the marker with a reel.
If you drop off your marker by boat it is recommended to attach the orange or white foam ring. This will increase
the visibility of your ATROSPOT by day and by night.
Accessories available
Orange foam ring
•
ATROTUBE adaptor
•
clear upper part with orange/black/glow yellow flight + EPDM o-ring
•
Other parts on request
•
Page 3
Patented illuminated marker ATROSPOT
1/2
rod
ATROPA Technologie – documentation technique ATROSPOT II
®
®
grease.
5 janvier 2009
Publicité
