Mounting The Inverter - SMA SUNNY BOY 3.0-US Instructions D'installation

5 Mounting
Prescribed clearances in accordance with the National Electrical Code
Canadian Electrical Code
Under certain conditions, the National Electrical Code
CSA C22.1 specify greater clearances.
• Ensure that the prescribed clearances in accordance with the National Electrical Code
or Canadian Electrical Code
☐ Maintain the recommended clearances to walls as well as to other inverters or objects.
☐ If multiple products are mounted in areas with high ambient temperatures, increase the
clearances between the products and ensure sufficient fresh-air supply.
200
(8)
Figure 6 : Recommended clearances(Dimensions in mm (in))
5.2

Mounting the Inverter

Additionally required mounting material (not included in the scope of delivery):
☐ 2 screws suitable for the support surface (diameter: 8 mm (5/16 in))
☐ 2 washers suitable for the screws
☐ Where necessary, 2 screw anchors suitable for the support surface and the screws
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or dropped while being transported or
mounted.
• Transport and lift the product carefully. Take the weight of the product into account.
• Wear suitable personal protective equipment for all work on the product.
26 SBxx-1SP-US-41-IA-xx-12
®
CSA C22.1
®
CSA C22.1 are adhered to.
200
(8)
CAUTION
SMA Solar Technology AG
®
or the Canadian Electrical Code
200 500
(8) (20)
Installation Manual
®
or
®
®