Publicité
Les langues disponibles
Les langues disponibles
Rules for safe operation
1. Never insert fingers, pencils, or any other object through the grille when fan is running.
2. Disconnect fan when moving from one location to another.
3. Be sure fan is on a stable surface when operating to avoid overturning.
4. DO NOT use fan in window, rain may create electrical hazard.
5. Household use only.
Part figure 2
1. Front grill
2. Circlip
3. Grill clip
4. Blade
5. Plastic nut
6. Rear grill
7. Motor shaft
8. Oscillating clutch knob
9. Pedestal
10. Spinner
11. Base
12. Piano switch
13. Tight
14. Loose
Assembly of base
1. Detach screw from base of the fan.
2. Match locking tab to base and click into position.
3. Tighten the screw in the base to secure the fan to the base.
Be careful : ensure that the fan is switched off from the supply mains before removing the guard.
Grill & fan blade assembly
1. Unscrew the spinner clockwise (or take the spinner out from the bag) and the plastic nut counter clockwise to remove
both of them. Fix the rear grill to the motor then tighten the plastic nut again. (Fig.1)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into groove of the blade. Turn the spinner counter
clockwise to tighten the blade. (Fig.2)
VENTILATEUR A POSER Ø30CM 40W – Ø12'' 40W DESK FAN
Notice
BRICODEAL SOLUTIONS – 4 rue Yves GLOTIN – CS40005 33083 BORDEAUX CEDEX - FRANCE
Publicité
