Donauer High Efficiency 3.0 Notice D'installation Et D'utilisation page 66

EN
Status message
An error was
detected
Not enough
sunlight
Invalid grid
conditions
MSD not ready
Tab. 10: Status messages of errors that prevent the self test from running
64
When the self test has finished, proceed as follows:
7. Press  several times until the status message Self
test passed is displayed (Fig. left).
8. Press SET to confirm the result of the self test. The sta-
tus display appears.
Description
An internal error prevented the self test
from starting.
The self test was not started or was can-
celled due to insufficient sunlight, especially
in the evening/at night.
The self test was cancelled due to invalid
grid conditions, e.g. due to insufficient AC
voltage.
The self test was not started because the
inverter was not ready for operation.
Remedy
Contact your installer if this error
occurs frequently.
Repeat the self test during the day
when the inverter is feeding the
grid.
Repeat the self test later.
Repeat the self test a few minutes
later when the inverter is ready for
operation and is feeding.
742.641 | 11.43