Transportation; Basics; Technical Data - latAI LuftLicht Mode D'emploi

6

Transportation

This section contains information on the external and internal transport of the
electrical device.
Transport is the change of location of the electrical equipment by manual or
technical means.

Basics

Transport room
In the case of in-house transport, the electrical equipment is transported on the
company premises from one installation site to another installation site.
Legislation
In-plant transport of the electrical equipment is carried out in accordance with
the legislation of the country in which the electrical equipment is transported out
of the plant.
Transport units
To prevent damage during transport, the electrical device must not be
transported with the power supply unit connected. During external transport, the
two units (air-light, power supply unit) that make up the electrical device are
transported.
Environmental conditions
Off-site transportation can be performed under the following environmental
conditions:
•
Ambient temperature: -20 - +60 °C
•
Relative humidity: 0 - 95 %.

Technical data

Means of transport
For safe internal transport, a means of transport is required that meets the
following requirements:
•
The load capacity must be dimensioned so that the mass of the electrical
device can be safely supported
•
The size of the transport surface must be such that the electrical
appliance can be safely placed on the transport surface without falling off.
LuftLicht
20001.1
Original operating instructions
Transportation
41 from 135
12/5/2020