Preparations - Kenwood KDC-X896 Guide De Démarrage Rapide

Preparations

Release
[DISP]
Exiting the Demonstration mode
Turn off the Demonstration mode when
you use the unit for the first time after
installation. (KDC-X896/ KDC-BT852HD/
KDC-X496/ KDC-452U only)
1
Press the Control knob to quit the
Demonstration mode when the message
"To cancel DEMO Press the volume knob"
is displayed (approx. 15 seconds).
2
Turn the Control knob and press it
when "YES" is displayed.
The Demonstration mode can also be
canceled in the Function Setting mode.
Refer to <Demonstration mode setting>
(page 36) in Instruction manual
Adjusting the clock
1
Press the [DISP] button several times to
display the clock.
2
Press and hold [DISP] button.
3
Turn the Control knob to adjust the
hour, and then press the Control knob.
4
Turn the Control knob to adjust the
minute, and then press the Control
knob.
4 | Quick Start Guide
Control knob (Volume knob)
Detaching/ Reattaching the
faceplate
¤
• Remove the faceplate at once after
pressing the Release button; otherwise it
can fall down due to vibration.
• The faceplate is a precision component of
the unit and can be damaged by shocks
or jolts.
• Keep the faceplate in its case while
detached.
• Do not place the faceplate (and case) in
areas exposed to direct sunlight, excessive
heat or humidity. Also avoid places with
too much dust or the possibility of water
splashing.
Press the Release
button.