Connecting Inverter Cables - Schumacher PID-760 Manuel D'utilisation

Using the inverter with any of these devices may cause the device to run warmer
or overheat.
Modified sine waveform
produced by inverter
IMPORTANT: If you are using the power inverter to operate a battery charger,
monitor the temperature of the battery charger for about 10 minutes. If the
battery charger becomes abnormally warm, disconnect it from the inverter
immediately.
NOTE: You can use an extension cord from the inverter to the device without
significantly decreasing the power being generated by the inverter. For best operating
results, the extension cord should be no longer than 50 feet.

4. CONNECTING INVERTER CABLES

The inverter and power source must be in the OFF mode.
IMPORTANT: Make sure to connect your inverter only to a 12 volt power supply.
INVERTER CONNECTION:
1. Locate the positive and negative plastic terminals on the right side of the
inverter and remove the terminal caps completely.
2. Install the positive (red) cable ring lug onto the positive (red) terminal screw.
Install the negative (black) cable ring lug onto the negative (black) terminal
screw. Tighten each terminal so that the cable cannot come loose.
CONNECTING INVERTER CABLE TO A VEHICLE (100 watts maximum):
1. Remove the cigarette lighter from its outlet.
2. Push the 12 volt power plug firmly into the outlet.
Diagram A Diagram B
Pure sine waveform
typical of home AC outlet
• 8 •