Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
US
CA
Figure 39
Figure 40
Remove the power
cord from the grommet
in the access cover.
CARE AND CLEANING
Remove 11
screws from
around the
perimeter of the
access cover
with a
⁄
" nut
5
16
driver.
Soak up water
from plastic
Clean out
drain pan if
debris
necessary
17. Leave door open and allow to completely dry out be-
fore closing door.
18. Thoroughly clean the door gasket with anti-bacterial
cleaner to be followed with clean rinse water to remove
any residual chemicals.
19. Thoroughly clean the exterior with a cleaner approved
for stainless steel . Do not use any abrasive cleaners
or scouring pads.
20. Any mounting hardware / fasteners that are showing
signs of corrosion should be replaced.
21. Once the exterior has been thoroughly cleaned, you
may want to apply a coating of car wax to help protect
against spotting from moisture, dirt, and debris that
may accumulate on the surfaces during the Winteriza-
tion period.
After completion of the above, you may choose to store the
unit indoors, although this is not required.
Start-Up After Long-Term Storage:
1. Connect the unit to electrical power.
2. If stored outside, it is recommended that the unit again
be thoroughly inspected per the storage instructions
above to address any dirt or debris from the weather
and/or animals/insects.
3. Turn unit on and confirm your desired control settings.
4. Allow 24-hrs for the unit to stabilize before loading
contents.
18
Publicité
Chapitres
Table des Matières
