Faucet Cleaning; Front Grille; Cabinet; Interior - Fisher & Paykel DCS RF24TR1 Instructions D'installation, D'utilisation Et D'entretien

Outdoor beer dispensers
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

US
CA
Cleaning and Maintaining Dispensing System
The dispensing system needs to be cleaned between
usage to prevent spoilage and/or foul taste in your beer.
Cleaning
Remove the keg coupler from the keg if necessary. Close the
gas valve(s) below the regulator, remove both the red gas
line(s) and clear beer line(s) from the keg coupler(s) by remov-
ing the plastic hose clamps (See Figure 33). Soak and brush
the keg coupler in hot water or a sanitizing solution. Rinse
thoroughly with clean water. Dry all parts and reassemble.
Hose clamps can be
released by a lateral
movement to the head.
Figure 33

Faucet Cleaning

Turn off the gas supply with the shutoff valve(s) under the
regulator (see Figure 29 or 30) and open the faucet to re-
lieve the pressure. To remove the faucet from the tower use
the spanner wrench provided. Place the pin on the wrench
into the hole on the faucet collar and turn clockwise ↷ to
remove the faucet. (See Figure 35).
Remove the knurled cap from the faucet body just below
the handle and pull the handle assembly from the faucet.
This will allow the shaft to be removed from the back of the
faucet, see Figure 36.
Place pin on
wrench into hole
in faucet collar.
CARE AND CLEANING
Figure 34
Figure 35
After removing the
handle the shaft will
slide out the back of the
faucet
Figure 36
Soak all faucet parts in hot water or a solution of hot water
and a sanitizing solution. Do not use soap. Rinse thorough-
ly with clean water.
Reassemble faucet, assemble faucet to tower (be sure
faucet is in off position), and turn on gas valve.

Front Grille

Be sure that nothing obstructs the required air flow openings
in front of the cabinet. At least once or twice a year, brush or
vacuum lint and dirt from the front grille area (see page 4).
CAUTION
!
SHOCK HAZARD: Disconnect electrical power from the
appliance before cleaning with soap and water.

Cabinet

The stainless steel cabinet can be washed with either a
mild soap and water and thoroughly rinsed with clear water.
NEVER use abrasive scouring cleaners. Dry thoroughly
with a terry towel.

Interior

Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
Care of Appliance
1. Avoid leaning on the door, you may bend the door
hinges or tip the appliance.
2. Exercise caution when sweeping, vacuuming or mop-
ping near the front of the appliance. Damage to the
grille can occur.
3. Periodically clean the interior of the appliance as needed.
In the Event of a Power Failure
If a power failure occurs, try to correct it as soon as pos-
sible. Minimize the number of door openings while the
power is off so as not to adversely affect the appliance's
temperature.
16
Unscrew knurled
cap on faucet body
and remove handle
assembly

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Dcs rf24tl1Dcs rf24btr1Dcs rf24btl1

Table des Matières