Air and Me Solnan Guide D'utilisation page 10

ACCESSORIES
FILTRATION CARTRIDGE
To discover at www.airandme.fr
The water fi ltration cartridge of Solnan is
made of ceramic beads. It guarantees a
healthy and good quality steam by elimina-
ting the excess of calc and bacteria. Easy
to use, it has to be screwed inside the tank
cap and then will remain immersed in water.
We recommend you to change it every 4
to 6 months depending on the use of the
appliance and of the hardness of the water
you are using.
AROMATHERAPY
To discover at www.airandme.fr
air&me offers a wide range of essential oils
that are made in France.
Let yourself be tempted by our Synergies
range as well as by the range "Les Essen-
tielles", 100% natural oils.
The way to get the most out of your Solnan
humidifi er while enjoying the benefi ts of aro-
matherapy.
18
FAQ
Circumstance Reason
> The product is not correctly
plug or there is an electrical
problem.
> There is a problem on the
The product
electrical system of your
does not work
house.
> The tank is empty.
> The tank is not properly
placed.
The power
indicator is lit, but
the appliance
> The humidity rate selected on
does not
the hygrostat is reached.
produce steam
at the outlet
> Your hands are too wet when
The control panel is
you are using the control
not working
panel.
The steam
> The tank is not properly
comes out of the
placed.
appliance base
> The room to humidify is
oversized.
> The hygrometer sensor is dirty.
> The hygrometer sensor is
The indicated
defective.
humidity rate is not
correct
> The pipe is facing the
humidity sensor.
> Humidity sensor has a margin
of error of ±5%.
> The product is new.
> The water in the tank is dirty
Moisture produced
(stagnant or contaminated).
has an unpleasant
smell
> There is a residual odor
coming from the diffusion of
essential oils.
Solution
> Plug the socket correctly and
check the voltage and the good
functioning of your electrical
system. Avoid multi sockets.
> Fill the tank.
> Push and place the tank properly.
> Change the operating mode or the
desired humidity rate.
> Dry your hands before using the
control panel.
> Replace the tank properly.
> Move the appliance into a room
with an appropriate surface area.
> Clean the hygrometer by blowing
into the sensor hole.
> Contact your reseller for service
support.
> Turn the pipe so that it is not facing
the humidity sensor.
> Compare it with another hygrometer
to check if the hygrometer of the
appliance is defective.
> Empty the tank and base and wash
and dry both parts before turning
the unit on again.
> Change the diffusion cotton.
19