Publicité
FIG.3
FOR WALL UNITS 72" AND HIGHER, YOU MUST INSTALL
A WALL ANCHOR BAR FOR EACH SHELVING SECTION.
*SEE FOR MORE INFORMATION.
NOTE: THE 14 1/2" WALL SECTION IS EITHER
PERFORATED OR PLAIN SOLID METAL.
CHART FOR POSTS VS BACKS
NUMBER OF 14 1/2" WALL AND/OR PLAIN BACK 7 1/4"
REQUIRED FOR DIFFERENT POST HEIGHTS
*NOTE: THE PLAIN BACKS (7 1/4"H) MUST BE
INSTALLED FIRST AT THE BASE
TITLE
I:\dessins\INSTRUCTION\INS-111XXX\INS-111022.idw
WALL UNIT:
108"= 7X 14 1/2"
96" = 6X 14 1/2" + 1X 7 1/4"
90" = 6X 14 1/2"
84" = 5X 14 1/2" + 1X 7 1/4"
80" = 5X 14 1/2"
72" = 4X 14 1/2" + 1X 7 1/4"
66" = 4X 14 1/2"
60" = 4X 14 1/2"
54" = 3X 14 1/2" + 1X 7 1/4"
52" = 3X 14 1/2" + 1X 7 1/4"
48" = 3X 14 1/2"
S RIE TALEX
E SERIES
STEP 3
FIRST, SLIDE IN THE 7 1/4" H METAL BACK FOLLOWED BY
THE 14 1/2" H METAL BACK. PLACE IN THE WELDED STRIP
OF THE END POST. ON BOTH THE FRONT AND REAR OF
THE HD END POST (UPRIGHT). SEE THE GRID OF CHART
POSTS VS BACKS. (FIG.3)
THE HORIZONTAL EDGE OF THE PLAIN AND
PEFORATED BACK PANELS HAVE A CONVEX AND
CONCAVE HORIZONTAL EDGE. MAKE SURE THE
CONCAVE EDGE IS FACING THE BOTTOM WHEN YOU
SLIDE THE PANEL DOWN THE WELDED STRIP.
REPEAT THE SAME PROCESS FOR EACH PANEL TO
ENSURE A TIGHT FIT. (FIG.4)
NOTE
CONVEX EDGE
FACING UP
PERFORATED OR
PLAIN BACK 14 1/2"
(ITEM#9)
CONCAVE
CONVEX
PLAIN BACK 7 1/4"H
(ITEM#8)
CONCAVE EDGE
FACING DOWN
METHOD OF
INTERLOCKING
THE BACK PANELS
DRAWING
INS-111022
FIG.4
PAGE
REV
-
16
21
OF
Publicité
