Fisher & Paykel DCS CAD1-30 Instructions D'installation Et Guide D'utilisation page 15

INSTALLATION
SINK DRAIN ASSEMBLY INSTRUCTIONS (OPTIONAL)
6. Set the Side Burner/Sink securely on a table and attach
the faucet to the sink as shown in
Fig. 36.
CAUTION:
Finger tight first, then use a wrench.
7. Feed the 3-foot water supply hose/air vent tube
through the hole at the bottom of the burner box, and
attach it to the faucet (Fig. 37).
CAUTION:
Finger tight first, then use a wrench.
8. Perform the following instructions for head installation:
WARNING!
Excessive weight hazard. Use two or more people to
move and install sink/burner assembly onto the cart.
OUTDOOR APPLIANCE HEAD PREPARATION:
A. First you will need to remove the angle brackets from
the side of the unit and replace them with cart mount
brackets (Fig. 38). Unit is shipped prepared
for island installation.
Rubber Washer
Lock Washer
Lock Nut
13
Fig. 36
AIR VENT
TUBE
Fig. 37
Fig. 38
SCREWS