Jennair W10526078 Instructions Pour L'installation page 23

Cuisinière à bi-combustible encastrable à évacuation descendante de 30'' (76,2 cm)
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Unscrew the regulator cap and remove the plastic cover.
A. Plastic cover
B. Regulator cap
4. Flip the regulator cap over and replace the plastic cover.
A
A. Natural gas position
B. LP gas position
5. Screw the regulator cap securely back into place. Do not
overtighten.
To Convert Surface Burners
1. If they are installed, remove the burner grates.
2. Remove the burner caps.
3. Using a Phillips screwdriver, remove the burner base.
A
B
A. Burner cap
B. Gas tube opening
A
B
B
C
D
C. Burner base screws
D. Burner base
4. Apply masking tape to the end of a ⁹⁄₃₂" (7 mm) nut driver to
help hold the Natural gas orifice spud in the nut driver while
changing it. Press nut driver down onto the Natural gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set Natural gas orifice spud aside.
A. Natural gas orifice spud
Use the following chart for correct LP gas orifice spud for each
burner. Refer to the gas information plate on the side of the
bottom oven frame for proper sizing of LP gas orifice spuds for
each burner location.
LP Gas Orifice Spud Chart
Location
Burner Rating
Right Front
14,000 BTU
Right Rear
4,000 BTU
Left Front
8,000 BTU
Left Rear
8,000 BTU
5. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. See the "LP Gas Orifice Spud Chart."
6. Replace burner base and hand tighten the screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
9. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with package containing literature.
10. Replace burner grates.
11. Plug in range or reconnect power.
12. Complete installation. See "Make Gas Connection" and
"Electronic Ignition System" sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
¼" to ½" long. The outer cone is not as distinct as the inner
cone. LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
A
Color
Number
Red
114L
Blue
64L
Clear
35L
Clear
35L
23

Publicité

Table des Matières
loading

Table des Matières