Dc Protector - Yamaha EF2000iS Manuel D'utilisation

A
B

DC protector

The DC protector turns to
2
when electric device being connected to the generator
1
is operating and current above the rated flows. To use
this equipment again, turn on the DC protector by
pressing its button to
1
Direct current is output. (This is the default position.)
2
Direct current is not output.
NOTICE
7PB-223
Reduce the load of the connected electric device
below the specified rated output of the generator
if the DC protector turns off. If the DC protector
turns off again, stop using the device immediately
and consult a Yamaha dealer.
å For Australia
7PB-233
∫ For Europe, Korea and Argentina
"I" (ON)
"3" (OFF)
– 10 –
"3" (OFF) automatically
"I" (ON).