Removing Expresscards - Fujitsu LifeBook AH530 Guide D'utilisation

See your ExpressCard manual for instructions on the installation of your card. Some cards may require
that your notebook is off while installing them.
To install an ExpressCard, follow these steps:
1
When not in use, you should keep the ExpressCard plug (Figure 28) inserted in the slot to help prevent system
contamination.
2
Make sure there is no ExpressCard or ExpressCard plug currently in the slot. If there is, see Removing
ExpressCards.
3
If the eject button is extended, press it in until it clicks.
4
Insert your ExpressCard into the slot with the product label facing up. If you are inserting a 34 mm card, be sure
to align it with the left side of the slot when inserting it.
5
Push the card firmly into the slot until it is seated in the connector.

Removing ExpressCards

See your ExpressCard manual for specific instructions on removing your card. Some cards may require
your notebook to be in Standby Mode or Off during removal.
•
W
INDOWS HAS A SHUTDOWN PROCEDURE FOR
A CARD
TO REMOVE DEVICES USING THE
•
I
F THE DIALOG BOX STATES THAT THE DEVICE CANNOT BE REMOVED
CLOSE ANY OPEN APPLICATIONS AND SHUT DOWN YOUR NOTEBOOK
To remove an ExpressCard, unlock the card or card plug from the slot by pressing it in, then releasing it.
This will eject the card slightly out of the slot, allowing you to remove it.
. (R
EVIEW YOUR OPERATING SYSTEM MANUAL FOR THE CORRECT PROCEDURE
S
AFELY
61 - Using ExpressCards
E C
XPRESS ARDS THAT MUST BE FOLLOWED BEFORE REMOVING
R H
EMOVE ARDWARE ICON IN THE SYSTEM TRAY
,
YOU MUST SAVE ALL OF YOUR OPEN FILES
.
.) I
T IS GOOD PRACTICE
.
,