OHAUS STARTER 5000 Manuel D'instructions page 11

STARTER 5000 Bench pH Meter
Information, measure and calibrate tap area
The information area is also the shortcut to enter the setting interface:
"
Endpoint:"
"
Sensor ID:"
"
Sensor Cond:"
There are 3 sensor condition icons:
Slope: more than 95%
and offset: ± (0-15) mV
Electrode condition is good
Calibration reminder icon. Set the time you want the meter to alert you to do
calibration from last calibration. When the time is reached, this icon will be displayed
and blink to remind that it is time to perform a calibration.
"
Buffers:"
This area displays the current buffer group, tap this area to enter the interface to
select the buffer group.
Start icon. Tap this icon and the meter will begin measurement, the signal
icon
Calibration icon. Tap this icon to start calibration.
Save icon. After saving the current measurement result (endpoint reached), this
icon color will change from black to light gray
already been saved and cannot be saved twice.
Output icon. Output data to external device such as a printer.
If "Shut off connection" is chosen in System Setting ►Output, the save
icon
same position.
Tap this area to enter the interface to set the endpoint mode. Available
modes are Auto, Manual and Time endpoint. The current endpoint mode is
displayed.
Tap this area to enter the interface to select, set or change the sensor ID.
The current sensor ID is displayed.
Tap this area to enter the sensor calibration data interface. The current
sensor performance icon (judged by calibration data) is displayed.
Slope: 90-95%
or offset: ± (15-35) mV
Electrode condition is
acceptable
will blink. The start icon area will show the stop icon
will be displayed .Otherwise the output icon will be displayed in the
Slope: less than 90%
or offset: ± (35-60) mV
Electrode condition is not
good or needs cleaning
, indicating that the reading has
EN-7