EMAG Emmi 12HC Mode D'emploi page 13

4. non conventional use
In case of non conventional use of the equipment danger for life and
limb as well as danger for property may occur. Therefore a non conven-
tional use is prohibited. In case of non conventional use EMAG AG will
not be liable for possible damages and will not warrant for the correct
and functionally work of the components. In order to avoid non conven-
tional use of the ultrasound cleaning equipment the following directions
are to be considered:
• The equipment may only be operated with the voltage printed on
the type plate on the backside/ bottom side of the housing
(shockproof socket).
• No fl ammable or aggressive chemicals (i.e. acids etc.) must be
used for operation of the equipment. If necessary, use glass
container em 50 DG.
• During operation do not touch the liquid.
• In case of transportation damage, don`t connect the equipment
with main source.
• Do not clean creatures (i.e. fi nger nails, animals etc.) in the
equipment.
• The equipment must only be operated with the correct level of
water (water till mark, approx. 1 cm below upper brim).
This must be controlled if equipment is operated for a longer time.
• Strongly contaminated goods shall be positioned in the equipment
with the contaminated side to the bottom – do not staple goods.
• The goods to be cleaned must not be positioned directly onto the
bottom of the tub – use the basket.
• If the equipment is operated for a longer time, do not stay longer
than 4 hours within 1 m distance to the equipment.
• The equipment must only be operated indoor and within a dry
environment.
• It is normal, that the upper brims warm up at longer operation.
• Before emptying the tub, the power connector must be
disconnected from the main source.
13