Zodiac Pool Systems Aquasphere Kontiki 2 Guide Du Propriétaire page 5

Slide the wheel deflector onto the end of
the hose that attaches to the cleaner.
4
Connect the Cleaner
1. Submerge the cleaner and flood it
with water. When bubbles stop coming
from the extension pipe, connect the
hose to the cleaner.
2. Turn on the filtration system and fill the
hose with water by placing it in front of
a return inlet until it is flooded. Turn off
the pump.
5
Connect the Hose
The FlowKeeper
on all installations. The valve regulates flow
to ensure the pool pump and cleaner run
properly. It is pre-set at the factory to optimize
the performance of the cleaner, but offers
three settings to adjust the flow. The lower
the setting number, the lower the flow.
To adjust, pull the handle and move setting up
or down. The red tab can be used to open the
valve and stop the cleaner.
Install the FlowKeeper Valve with the arrow
facing down towards the skimmer pipe.
Using the parts as indicated, connect the hose
to the skimmer. For Canadian installations,
the hose protector attaches to the hose section
that goes into the skimmer.
Be sure to keep the hose and cleaner
completely submerged to keep air out of
the system.
Once the hose is connected, turn on the
pool pump and begin cleaning. Installation
is complete.
If further assistance is needed, contact Technical Support
at 1-800-822-7933 in US/Mexico or 1-888-647-4004 in Canada.
® Valve must be used
Hose Protector
(Canada only)
FlowKeeper
Adjustment
4-1/2"
Connector
45 Elbow
(U.S./Mexico only)
FlowKeeper
Valve
Valve
Cuff
5