Configuring Your Printer - Belkin F8T030 Guide D'installation Rapide

P74186ea_F8T030_QIG.qxd 11-04-2003 08:51
4. Once the software installation is complete, you will receive a message confirming
the installation process.

Configuring your Printer

Note: You must add a printer as a "local" printer (not as a "network" printer), and select the printer port
named "Belkin" (see step 4). To set up the printer:
1. Go to the Control Panel and open the "Printers" folder.
2. Select the printer that is connected to the AP.
3. Select "File" then "Properties" from the menu. (You may also right-click on the
printer and select "Properties".)
Page 10
Software Setup Software Setup
4. Under the "Ports" tab, you will see a list of ports that are installed on your
computer. Highlight the port named "Belkin" and click on "Configure Port".