Belkin F8T030 Guide D'installation Rapide page 4

P74186ea_F8T030_QIG.qxd 11-04-2003 08:51
Hardware Installation
2. Connect the included power adapter into an available power outlet. Attach the
barrel plug into the power jack of the AP. You should see the power LED light turn
on, the system light blink a few times, and then the system, LAN, USB 1, USB 2,
and Bluetooth lights will blink repeatedly as the AP initiates itself. The initiation
process will take approximately 20 seconds.
TIP: The system LED blinks once per second indicating that the AP is functioning properly. The system light
will blink three times per second if the IP address has not been set. If any lights other than the power light
remain solid, consult the Troubleshooting guide at the end of your User Manual. If the problem persists,
contact Belkin Technical Support at 00-800-223-55460.
Page 6
Hardware Installation
Connecting USB Printers (optional)
The AP supports up to two USB printers. Please do not connect any devices other than
a USB printer directly to these ports.
1. Attach one end of a USB cable to one of the USB ports on the AP.
2. Connect the other end to an available
USB printer.
3. Repeat steps 1 and 2 above for a
second printer.
Note: You must have the printer driver installed
in each computer you wish to print from prior
to use.