Baxtran IB10-S Mode D'emploi page 34

APPROVAL CONFIRMITY
DISPLAY
LF 6
!
GRAVITY
LF 7
*Introduce the gravity of your zone before doing the first calibration.
*Introduce the gravity of destination after doing the calibration.
*The value of the gravity will be denied if it is bigger than 9.83217 ( gravity of the pole) or inferior to 9.78031 ( gravity of the
equator).
Value of factory: 9.8035
DISPLAY
LF 7
-00-
9.8035
9.8035
INITIAL ZERO
SEtZ Y resets of the point of zero every time that the scale is begun again.
SEtZ n resets of the point zero OFF
DISPLAY
LF 8
SetZ Y
LF 8
34
LF 6
nonE Version not approved
DON'T MODIFY, IN NO WAY, THIS PARAMETER. IT MUST ALWAYS BE CONFIGURED AT
nonE.
The change of this parameter implies the blocking of some functionalities.
Press the key
•
again automatically.
The screen is going to show the number of pre-calibration during one second.
•
Press the key
•
Use the keys ,
•
of gravity ( press ESC to exit from the configuration and go back to the menu LF7)
LF 8
Press the key to start or the key
•
automatically.
• Use the key and then the key
to exit from the configuration and go back to the menu LF8)
• Use the keys ,
the key to exit from the menu and the scale will start again automatically.
DESCRIPTION AND SEQUENCE OF USE
DESCRIPTION AND SEQUENCE OF USE
to continue or the key
to continue.
0 ~ 9
and ,
DESCRIPTION AND SEQUENCE OF USE
to exit from the menu and the scale will start again
to choose the mode of zero initial ( press the key
and then the key
USER'S MANUAL IB10-S EN
to exit from the menu and the scale will start
and then the key to introduce the value
to continue with other adjustments o press