General Safety Information; Workplace; Operating Instructions - Forsthoff QUICK-S-ELECTRONIC Instructions D'emploi

General Safety Information

CAUTION! Read all the instructions. Errors in
observing the following instructions can result in
electrical shock, fire and/or serious injuries. The
term "electrical tools" used below, refers to mains-
operated electrical tools (with a mains cable)
and to battery-operated electrical tools (without a
mains cable).
KEEP THESE INSTRUCTIONS IN A SAFE
PLACE.
Explanations for utilized symbols
Observe operating manual
Danger of explosion
Danger of fire
Hot surface
The device
· has been designed and tested in accordance
with EN 60335-1 in connection with EN 60332-
2-45.
· is CE certificated
· has left the plant in perfect condition as far as
safety is concerned.
In order to maintain this state, it is necessary
to observe the contents of this safety informa-
tion when handling the device (transportation,
storage, installation, commissioning, operation,
servicing, de-commissioning) as well as the
rating plates, labelling and safety information at-
tached to the device, otherwise it could endanger
persons and damage the device itself as well as
other equipment.
This safety information applies in the Federal
Republic of Germany. The relevant national rules
and regulations must be observed when it is used
in other states/countries. The generally valid
safety and accident prevention regulations must
be observed in addition to the references in this
Manual.
If the information in this safety information does
not suffice, then you can contact the manufac-
turer at any time at the indicated address.
Please check the packaging and file a complaint
with the forwarding agent immediately in the case
of any damages.
Please examine the device prior to commission-
ing to ensure that the device has no damages
of any kind. In the event of doubt, please ask a
qualified electrician for advice or contact the ad-
dress shown below.
If you assume that a danger-free operation
is no longer possible, then take the devic
out of operation and secure it from being restarted
unintentionally.
One must assume that a danger-free operation is
no longer possible
· if the device or the connection lead shows vis-
ible damages,
· if the device no longer functions,
· if it was stored under detrimental conditions,
· after severe demands due to transportation.

Workplace

Keep your working area clean and tidy. Disorderly
and non-illuminated working areas can result in
accidents.
Keep children and other people away from the
electrical tools while in use. You can lose control
of the device if you are distracted.
Use the device only for its intended use (see
below).
Do not reach into the flow of hot air. Touch-
ing the jet or the protective pipe can result
in burns when it is hot.
A fire can develop if the unit is not handled
carefully.
Caution when using the device near flammable
materials. Do not direct towards one and the
same point for an extended period of time.
Heat can be conveyed to flammable materials,
which are covered.
Never work with the device in surroundings
that could be explosive, or in which
flamable liquids, gases or dust can be found.
Electrical tools generate sparks, which can ignite
the dust or the fumes.
The connection lead may not come into
contact with hot parts.
Place on the stand and allow to cool off after use,
before it is packed away.
Operating Instructions EN
9