Tannoy AMS Serie Guide De Démarrage Rapide page 6

Table des Matières

Publicité

10
AMS Series
3. Unpacking
Every Tannoy product is carefully inspected before shipment. After unpacking, please inspect your product to ensure no damage has
occurred in transit. In the unlikely event of damage, please notify your dealer and retain all shipping materials as your dealer may require
return shipment.
4. Installation
Installation using included yoke bracket
1.
Fix the yoke bracket to an appropriate structural surface using a suitable fixing method.
2.
Remove the yoke trims from the product to access the bracket fixing points.
3.
Set the transformer tap as detailed in Chapter 5.
For indoor installation (proceed to step 5 for outdoor installation): Connect the euro-style plug to the wires, observing correct
4.
polarity. Use pins 1(+) and 2 (–) for connection of the loudspeaker. Use pins 3 (–) and 4 (+) for connection of additional loudspeakers in a
distributed line. NOTE: Tighten pins 3 and 4 even if not used to prevent vibration of the screws.
5.
For outdoor installation: Feed the loudspeaker wire(s) through the opening in the neck of the cable entry cover included with the
product.
Connect the euro-style plug to the wires, observing correct polarity. Use pins 1(+) and 2 (–) for connection of the loudspeaker. Use
pins 3 (–) and 4 (+) for connection of additional loudspeakers in a distributed line. NOTE: Tighten pins 3 and 4 even if not used to
prevent vibration of the screws.
6.
Place the loudspeaker inside the yoke bracket. Position buffers between bracket and loudspeaker as shown. Attach with supplied fixings
using a 5 mm Allen key. Use the longer hex screws supplied when mounting the yoke bracket.
7.
Connect the euro plug to the loudspeaker. For outdoor installation, attach the cable entry cover using a 3 mm Allen key and the included
screws. Orient the cover plate so that the neck opening is facing downward to minimise entry of moisture or particulates.
8.
Connect a secondary support line to the safety tab at the rear of the cabinet.
Optional multi-angle VariBall bracket
AMS 5 Multi-Angle Bracket
AMS 6 & 8 Multi-Angle Bracket
The optional multi-angle accessory bracket utilises a ball-in-socket design to enable free orientation of the loudspeaker at any angle on
either the horizontal or vertical axis. If desired, the loudspeaker orientation can be easily changed within minutes. Download the AMS
VariBall accessory bracket documentation for more details.
11
Quick Start Guide

Publicité

Table des Matières
loading

Table des Matières