Abus Secvest FUAA10010 Notice Abrégée page 49

SELECT
Press The bottom LED lights in blue.
SET
Press
You are now in programming mode and can
learn in the radio components. The 2nd LED from
the bottom lights up or flashes (lights = channel is
already occupied, flashes = channel is vacant).
Learn in operating units
You can use the first three channels for learning in
the radio components. To learn in operating units,
select the respective channel and make the unit
transmit a certain radio signal, in accordance with
its learn in procedure.
Once the signal is received successfully, the control
panel will beep twice and the LED will remain lit.
To switch a channel further up, please press
SELECT
The LED for the next channel will light up or
flash.
2
Learn in multiple operating units
If you want to learn in multiple operating units
(up to 3), select the respective channel and
repeat the previously described procedure.
If you now want to go on to learn in the detec-
tors, choose
LEDs 4-7 for the first detector group,
LEDs 8-10 for the second group and
LEDs 10-14 for the third group.
4
3
5
47