Cata X-MART Mode D'emploi Et D'entretien page 10

EN
ENGLISH
Series X-MART IPX4
INSTALLATION:
SAFETY WARNING: This extractor fan must be installed at least 2.3 metres off the ground.
Begin the installation by making a circular opening of 100 mm. (B-10), 120 mm. (B-12), 150 mm. (B-15) diameter in the
wall, ceiling or wall where the extractor is to be installed.
To remove the front cover (A), pull the cover outward. X-MART (Fig.1), X-MART MATIC (Fig.2).
Place the exhaust conduit (D) in the hole in the wall, ceiling or wall for exhaust of the air.
Fix the base of the housing (B) in place using the plugs and screws provided. It may also be fixed to the interior of the
ceiling using the 2 quickfit. Loosen the screws (F) until the wedges (G) are fully concealed in the housings (H) and can be
easily introduced inside the pipe. Tighten the screws until the wedges (G) firmly fix the extractor to the exhaust conduit.
Once the installation is complete, replace the front cover (A).
Note:
- This extractor is not designed to be used by people (including children) with physical, sensorial or mental capacity, or who
lack experience or knowledge about it, unless they have had supervision or instructions on how to use the hood by someone
who is responsible for their safety.
- Children must be supervised to ensure that they do not play with the extractor.
- The installation, electrical connections and adjustments must be performed according to the local rules by a
qualified person
- Do not install the exhaust pipe (D) of the extractor unit to a chimney, ventilation pipe or hot air conduit.
Before connecting the unit to pipelines, consult the local municipal regulations regarding exhaust air and ask the permission
of the person in charge of the building.
– Make sure that the ventilation is appropriate, especially when the extractor is used in conjunction with an
appliance with a combustion chamber.
– This extractor is designed for the ventilation of homes or similars premises.
– Do not use in premises where the room temperature is above 40° C.
–This extractor does not cause any interference in radio/television sets (Standard 2004/108/CE).