Krautli RVS 401 Mode D'emploi page 7

●Find the power wire(positive) of reversing light
and connect it to the red wire of the power box.
Then connect the black wire of the power box to
the ground(iron part of the vehicle).
Note:
To make better use of the product , we recommend
that the antenna is vertically positioned and not in
an airtight environment.
Step8: Running the power box cable
Secure the rear camera cable and power box cable with cable ties in the rear carriage. Be sure there are no electrical loads or metal between
the monitor and antenna to avoid impairing the transmission. The cables run may not interfere with the vehicle functionality!
Step9: Check the connection of the power box
First engage the hand brake and be sure the vehicle is not shifted into gear. Vehicles with automatic transmission must be in "P" for parking
lock. Turn the ignition to (II) but do not start the engine! Put the car charger into the vehicle's cigarette lighter to power on the monitor. If the
power box correctly connected, a signal will be transmitted to the monitor when putting the car into reverse and the monitor displays the
camera's viewing range.
Caution!
Due to differences in technical and design-related vehicle types, these instructions for use do not apply to all vehicle models.
Red(+)
Black(-)
Power box
Antenna
5
+ 12V-24V
Reversing light power wire
Reversing light
Ground
Camera
(iron part of the vehicle)