Krautli RVS 401 Mode D'emploi page 6

Step5: Hole for camera cable
Now look for an opening / drill a hole near the license plate opening into the interior of the vehicle ,
to thread the connector cable plug of the camera into the interior of the vehicle. For added visibility
and easy installation, remove the interior trim near the license plate.
Step6: Connect the camera cable
Now run the camera cable to connect the power box in the vehicle's interior / cavity. Be sure the cables aren't pinched or knotted. Connect the
plug of the camera cable to the 4-Pin socket of the power box.
Step7: Connect the power box wire
●Open the inner plastic panel and remove it from the hatch or tailgate. (The panels are usually
attached on the tailgate by clips. This may take a bit longer time to avoid clip damages. Once
this panel is removed, the work will be done easily.)
●How to find reverse light(Positive)?
a. Please switch the key to ACC position, then shift your car into R-gear.
b. Prepare a car test light, connect its clip or clamp to a known ground source, then use the pointed
end pierces the plastic insulation on a wire.If the bulb lights up, it means the wire may be the potential reversing light's positive power source.
c. Please shift your car into another gear, then use a test light to test all the wires which used to light up the bulb again, if there is one wire that
doesn't light up the bulb, it's the reversing light's positive power source.
4