Maintenance And Storage; Service And Repairs - Ardisam ION G2 Manuel De L'opérateur

Battery Charge Indicator Light Codes
The battery status lights will turn on automatically when the
auger is in use. To check the battery state when the auger is
not in use, or while charging the battery, press the button
adjacent to the status lights. The lights will turn on for 5
seconds to show the battery charge/status. Battery status
codes listed below:
ACTION
3 solid lights
2 solid lights
1 solid light
1 flashing light
2 flashing lights
3 flashing lights

MAINTENANCE AND STORAGE

Read the maintenance schedule and observe these
recommendations to extend the life of your electric auger.
Good maintenance is essential for safe, economical, and
trouble-free operation. To help you properly care for your
powerhead, the following pages include a maintenance
schedule, routine inspection procedures, and simple
maintenance procedures using basic hand tools. Other
service tasks that are more difficult, or require special
tools, are best handled by professionals and are normally
performed by a technician or other qualified mechanic.
The maintenance schedule applies to normal operating
conditions. If you operate your powerhead under unusual
conditions, such as sustained high-load, or use in unusually
wet conditions, consult ION® customer service for
recommendations applicable to your individual needs and use.
Maintenance and Schedule
MAINTENANCE ITEM
Check bolts and nuts
Battery Charge
Replace
Sharpen/Replace Blades
Check for parts online at www.ioniceaugers.com or call 800-345-6007 M-F 8-5 CT
MEANING
65-100% charge remaining
30-65% charge remaining
5-30% charge remaining
< 5% charge remaining
Battery internal fault.
Contact customer service
or replace battery.
Battery outside of
operating temperature range
(too hot or too cold)
Every 500
Before each complete
day's use charges Yearly
X
X
X
Long-Term Storage
If your ice auger will not be run for more than one month,
prepare it for long-term storage.
• For best results, store your battery with 2 or 3 indicated
lights of charge.
NOTE: You don't need to completely charge your
battery prior to long-term storage.
NOTE: You don't need to charge your battery
during long-term storage unless the charge drops
below 2 lights.
• Store battery in a cool dry place.
NOTE: Optimal storage temperature is 68° F.
• Avoid leaving the battery attached to the charger
or powerhead for a prolonged period of time.
IMPORTANT
CONNECT THE BATTERY TO THE CHARGER EVERY
THREE MONTHS TO ENSURE THAT IT MAINTAINS
A FULL CHARGE DURING EXTENDED STORAGE.
Transporting Your Ice Auger
• Remove the battery if transporting the auger.
SERVICE AND REPAIR
Service Information
At Ardisam, we build quality and durability into the design
of our products; but no amount of careful design by us, and
careful maintenance by you, can guarantee a repair-free life
for your auger. Most repairs will be minor, and easily fixed by
following the suggestions in the troubleshooting guide in
this section.
The guide will help you pinpoint the causes of common
problems and identify remedies.
For more complicated repairs, contact ION customer service.
A parts catalog is included with the product separately.
We will always be glad to answer any questions you have, or
help you find suitable assistance. To order parts or inquire
about warranty, call or write us at the address found below.
Ordering Repair Parts
Parts may be obtained from the store where your auger was
purchased or direct from the factory. To order from the factory,
call, e-mail, or order online at www.ioniceaugers.com:
X
E-mail: info@ioniceaugers.com
Please include the part numbers, part description,
quantity, model number and serial number.
ION G2 Electric Ice Auger
ION® Ice Augers,
A Division of Ardisam, Inc.
1-800-345-6007
Operator's Manual
7