BATTERY CHECK HIGH VOLTAGE
BATTERY VOLTAGE CELL LOW
BATTERY VOLTAGE CELL HIGH
VOL
BATTERY VOLERR CELL
CONNECT
TEMP OVER ERR
CONTROL FAILURE
REVERSE POLARITY
CONNECTION BREAK
SHORT ERR
INPUT VOLT ERR
VOL SELECT ERR
BREAK DOWN
BATTERY CHECK LOW VOLTAGE
Your Pro‐Tronik charger is covered by warranty for one year from the day of purchase.
Connection errors are not covered by the warranty.
Defective or not supported batteries are not covered by the warranty.
Short circuits are not covered by the warranty.
Any damage to the packaging, the charger, the supplied connectors / cables is not covered by the warranty.
Any usage out of the specified instruction or charger abilities cancels the product warranty.
Messages d'erreur
Voltage detected over the
battery voltage supposed to
be plugged in
The voltage of one cell is too
low
One cell has a too high voltage
Connection / voltage error
Temperature is too high
Voltage ( input / output /
(check) failure
Polarty of battery (output) is
inverted
Battery connector is unplugged
or malfunctionning.
Short Circuit detected
Input power supply voltage
error
The voltage you have setup is
not matching the voltage
detected by the charger for the
battery.
Hardware / software error
The voltage detected of the
attached battery is too low
compared to the voltage
indicated by user.
Warranty / Disclaimer
Check the number of cells and correct if
necessary
Check the battery and battery balance. If
voltage too low please contact the battery
manufacturer to ask about process to handle.
Check the battery balance and inspect carefully
the battery to search for any physical damage.
Do not insist on charging and do not launch a
discharge process without contacting your
battery manufacturer / distributor first.
Check all connectors and battery integrity
Stop any process and wait for the battery to
cool down before checking the battery.
Check battery, input power supply / battery and
contact immediately your distributor for any
assitance.
Check connection
Check all wires and connectors, and battery.
Check all cables / connectors and the balance
connector of battery.
Check the power supply, i cas of use of a
battery car, it might be discharged or you might
need to setup a lower input voltage low limit.
Contact your distributor for any advise or for
power supply check.
Check the battery and the connections, and
specify correct voltage /number of cells. For
Lithium Batteries, if the voltage can not be
detected correctly by the charger, please
contact the battery manufacturer / distributor
Stop any process, disconnect the charger from
power supplly and disconnect any battery
attached to the charger. Contact your
distributor technical support.
Check the number of cells and the battery state
( deep discharge ?).
Check with your battery manufacturer if
necessary before launching any process.