a2pro Pro-Tronik AP6-Pocket Mode D'emploi page 16

This program allows you to charge / discharge your Ni‐xx batteries. The work principles are the same for Ni‐Mh and
Ni‐Cd, only the delta Peak values are different following the program you choose. Please make sure to attach the
matching batteries (Ni‐Mh or Ni‐Cd) when using one or the other program.
This function allows you to charge your Ni‐xx battery. Just indicate the maximum charge
current, and launch the charge process. End of charge will be detected depending of the delta
Charge
Peak values entered in the "User Set Progam" ‐> "Ni‐xx sensivity".
This function allows you to cycle your batteries to bring them back to their optimal
performances, or to get rid of the "memory effect" of the battery. Nickel batteries develop a
Cycling
memory effect when they are not used / discharged at their maximum capacity. After some
time, they memorize the capacity requested during the last operations and will behave as if
they had that capacity as a maximum. Cyclig them from time to time will allow them to recover
their full performances. You can select the number of cycles ( from one up to 5), and you can
check the current drawed or charged on the screen once the process launched.
This functions allows you to discharge your battery with a current between 0.1 Ah and 1Ah,
and a discharge voltage limit between 0.1 and 25 Volts. The voltage you will input must match
Discharge
the voltage of the battery pack, not the voltage of a single cell ( expect if you connect a single
cell to the charger).
This program allows you to charge or discharge your Lead Acid batteries.
This function allows to charge lead Acid batteries from 2 up to 20 Volts. Please input the
charge current and nominal voltage of the battery connected. Please note that Lead Acid
Charge
batteries should be charged slowly, with 0.1C charge current ( 1/10 of their total capacity). It is
necessary, in most time, to disable the safety timer to avoid partial charge.
Same as above function, for discharging the battery.
Discharge
Your charger is featuring a user memory handling up to 5 personalised programs. You can save or recall these
programs at any time by getting inthis menu.
To save a program, select a memory slot between 1 and 5, then validate.
Choose the battery type, the voltage if necessary, and the maximum charge capacity.
Recording
Press « Enter » during 3 seconds, a « * »symbol should blink in top right of the screen.
Press Enter and select the charge current, and validate again.
For Lithium batteries, please check the number of cells and validate.
Then, press again "Enter" for 3 seconds, the message "Save" will appear for a few instants, the
program is now saved in the charger memory.
This function allows you to load a previously saved program. Choose the program number you
wish to load, and press « Enter » for 3 seconds. You will then arrive to the battery charge /
Replay
discharge program you had recorded in this program.
« Nim‐Mh / Ni‐cd » battery progam
« Pb Battery » progam
« Program Select » Menu detail