Assembling Procedure - Optika B-150D Serie Manuel D'instructions

7.3

Assembling procedure

1. Remove the dust cap from the microscope frame
and from the bottom of the observation head.
2. Insert the optical head above the stand and tight-
en the screw ①. (Fig. 1)
• Hold the head with one hand during the
locking in order to avoid that the head falls.
3. Insert one end of the USB cable into the connec-
tor on the back of the optical head and the other
end into one of the USB ports on your computer.
4. Insert both eyepieces into the tubes of the optical
head. (Fig. 2)
• For model B-150D-MRPL: only one eyepiece
is used as this model is monocular.
5. Insert the power supply jack in the socket placed
at the rear side of the microscope. (Fig. 3)
Page 8
①
F ig. 1 F ig. 1
F ig. 2 F ig. 2
F ig. 3 F ig. 3