Wind Speed - Aercus WS1093 Guide D'utilisation

Memory
1)
Touch the Memory section to activate the history data toggle display, the + and – button will be
flashing. Press the – button to toggle back to see earlier weather history data together with its time
stamp, press the + button to see more recent weather history data. When the history data is
displayed the corresponding time will be displayed in the time section area (the history data saving
interval is preset to 30 minutes). Note: Historical values for some variables are only available once
downloaded to PC and will appear as dashes on the Base Station.
2)
Touching the Memory section again will trigger the memory clear procedure, the word "CLEAR" will
be flashing and the full memory usage icon will be flashing. Pressing and holding the memory full icon
for 3 seconds will clear the memory.

Wind Speed

1) Touch the WIND SPEED section, the + and – button will be flashing. Touch the + button or –
button to shift the display between the Wind Average Speed and Gust Speed. Note: Average wind
speed is the average speed over the 48 second period between signal transmissions. In gusty
conditions this may appear as though wind speed is being under reported as low winds and high
winds are averaged across the 48 second interval. Setting wind speed to Gust will display the
maximum wind speed during the 48 second period which can often be more meaningful in these
conditions.
2) Touch the WIND SPEED section again, the + and – button will be flashing. Touch the + button or –
button to select the wind speed unit - km/h, mph, m/s, knots, or bft.
3) Touch the WIND SPEED section a third time to set the high alarm function, the +, ON/OFF and –
button will be flashing, the HI AL icon will light up. Touch the + button or – button to change the
value, hold the + button or – button for 3 seconds to change the number faster. Touch the ON/OFF
button to turn the alarm on or off (the alarm icon will be turned on indicating the alarm function has
been activated).
4) Touch the WIND SPEED section a fourth time to set the wind direction alarm function, the wind
direction arrow will start flashing. Touch the + or – button to select the desired alarm for wind
direction, press ON/OFF to enable or disable the wind direction alarm.
5) Touch the WIND SPEED section a fifth time to display the maximum wind speed record, the recorded
maximum value will be flashing, the MAX icon will light up. If you hold the maximum value for 3
seconds the maximum value will be reset to the current reading.
- 10 -
WS1093