ALPATEC MG 2.1 Mode D'emploi page 11

notice MG2.1-06 20/04/06
CAUTION :
if the water tank or ice cube tank are not in the right position, or if there is not enough water, the
appliance will be on "warning " mode, the alarm light indicator is red flashing.
• Releasing function :
If the ice maker stops during a round, press start button for more than 3 seconds to release the
remaining ice. Ice maker will then start again after you solve the problem.
• For safety purposes, make sure that the power is on « OFF » position and the appliance is unplugged
before any maintenance, repairing or cleaning operation.
- Clean the case with a soft and dry cloth.
- If the case has accumulated dust or is very dirty, use any mild household cleaner to remove any
stubborn stains, then wipe with clean lightly dampened cloth.
- Clean the water tank with warm water and neutral detergent.
• Do not use alcohol or organic solvent to clean the appliance. Do not use tool to clean ice making
chamber, water tank or ice cube tank.
• If you don't use the appliance for a long time, you should empty the water tank and the ice cube tank,
and make sure it is dustproof.
• Water tank and ice cube tank can not be use as containers.
IF YOU DISCOVER THAT YOUR APPLIANCE HAS UNUSUAL SYMPTOMS PLEASE CHECK THE
FOLLOWING FIRST :
SYMPTOM
Alarm indicator flash red without bip
Alarm indicator flash red with
2 successive bips
Alarm indicator flash red with
3 successive bips
Alarm indicator flash red with
4 successive bips
Ice cannot come out.
Ice is too small
The appliance makes no ice.
12:11 Page 11
CLEANING
CLEANING
TROUBLESHOOTING
TROUBLESHOOTING
POSSIBLE CAUSE / PROBABLE SOLUTION
Ice is full, open the ice cube tank and empty it.
Check the water level.
Check the ice cube tank is in right position.
Check the water tank is in right position.
Check there is nothing block ice making.
Check the air vent is not blocked or the temperature is
not too high.
Check the appliance is correctly plug or the machine is in
time delay protection situation.
11