Bluetooth Pairing - X by Kygo Xellence Mode D'emploi

X E L L E N C E E N G L I S H
Battery Capacity status
When connected to an Android or iOS device, the ear-
phones' battery power status is displayed in upper right
corner of the device's screen. On iPhone X and newer
iPhone models, the battery status can be shown by
sliding down the screen. Battery status can also be read
in the X by Kygo™ app.
Charging
A new set of earphones has enough power for pairing
and dialling out several times. When it has low battery,
please charge the charging case via USB cable for
2 hours and make sure the earbuds are placed correctly
in the charging case. During charging, red LED flashes.
Once fully charged, red LED remains off.
Clearing pairing records
Long press the MFB button for 5 sec. when earphones
are in pairing mode and a red LED blinks slowly three
times. The earphones will now enter pairing mode
again. The two earbuds need to be reset separately, so
repeat this action on both left and right earbud.
Reset earbuds
If the earphones crash, you can reset your earphone
by placing them into the charging case. Close the lid
and wait for a few seconds.

Bluetooth Pairing

First time pairing with one phone or other devices:
1. Place the earphones into the charging case and
close the lid. Remove the earphones from the
case and they will automatically power on and
enter pairing mode.
2. You will hear a voice alert saying,"ready to pair"
and the red and blue light flashes alternately.
3. Activate the Bluetooth function on your device and
select "Kygo Xellence". Follow the instruction to
enter "0000" as PIN if the mobile phone reminder
appears.
A blue LED flashes every 5 seconds when pairing
4.
is successful, and you will hear a voice alert
saying, "pairing complete". Xellence can now be
used to play your phone music or for phone calls.
Bluetooth Pairing
Pairing with a new device:
1. Make sure the earphones are powered ON.
2. Long press the MFB button on left or right side for
5 sec. to enter pairing mode.
3. You will hear a voice alert saying, "ready to pair"
and the red and blue light flashes alternately.
Activate the Bluetooth function on your device and
4.
select "Kygo Xellence". Follow the instruction to
enter "0000" as PIN if the mobile phone reminder
appears.
5. A blue LED flashes every 5 seconds when pairing
is successful, and you will hear a voice alert
saying, "pairing complete". Xellence can now be
used to play your phone music or for phone calls.