Appliance Handling Safety; State Of California Proposition; Electric Safety; Microwave Safety - Thermador MicroDrawer MD24JS Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE
APPLIANCE AFTER INSTALLATION IS COMPLETE.
IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE
LOCAL ELECTRICAL INSPECTOR'S USE.
WARNING
If the information in this manual is not followed
exactly, fire or shock may result causing property
damage or personal injury.
WARNING
Do not repair, replace or remove any part of the
appliance unless specifically recommended in
the manuals. Improper installation, service or
maintenance can cause injury or property damage.
Refer to this manual for guidance. All other servicing
should be done by a qualified technician.

Appliance Handling Safety

Unit is heavy and requires at least two people or proper
equipment to move.
Do not lift appliance by door handle.
Hidden surfaces may have sharp edges. Use caution when
reaching behind or under appliance.

State of California Proposition 65

WARNING
This product contains chemicals known to the State
of California to cause cancer, birth defects or other
reproductive harm.

Electric Safety

WARNING
Before you plug in an electrical cord or turn on power
supply, make sure all controls are in the OFF position.
WARNING
The appliance must be disconnected from the source
of supply before attempting the installation.
For appliances equipped with a cord and plug, do not cut or
English 4
remove the ground prong. It must be plugged into a matching
grounding type receptacle to avoid electrical shock. If there
is any doubt as to whether the wall receptacle is properly
grounded, the customer should have it checked by a quali-
fied electrician.
If required by the National Electrical Code (or Canadian Elec-
trical Code), this appliance must be installed on a separate
branch circuit.
Installer – show the owner the location of the circuit breaker
or fuse. Mark it for easy reference.
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned ON
accidentally.
Be sure your appliance is properly installed and grounded by
a qualified technician. Installation, electrical connections and
grounding must comply with all applicable codes.

Microwave Safety

PRECAUTIONS TO BE OBSERVED BEFORE AND DURING
SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCES-
SIVE MICROWAVE ENERGY
• Do not operate or allow the oven to be operated with the
door open.
• Make the following safety checks on all ovens to be ser-
viced before activating the magnetron or other microwave
source, and make repairs as necessary:
1. Interlock operation
2. Proper door closing
3. Seal and sealing surfaces (arcing, wear, and other dam-
age)
4. Damage to or loosening of hinges and latches
5. Evidence of dropping or abuse
• Before turning on microwave power for any service test or
inspection within the microwave generating compartments,
check the magnetron, wave guide or transmission line, and
cavity for proper alignment, integrity, and connection.
• Any defective or misadjusted components in the interlock,
monitor, door seal, and microwave generation and trans-
mission systems shall be repaired, replaced, or adjusted
by procedures described in this manual before the oven is
released to the owner.
• A microwave leakage check to verify compliance with the
Federal Performance Standard should be performed on
each oven prior to release to the owner.