AUTO-HAK J15A Mode D'emploi page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
9
4
1
A
6
8
This towbar is designed to assembly in following car:
HYUNDAI H200; SATELITE/STAREX (H1) VAN, produced since
01.1997 till 01.2008, catalogue no. J15A and is prepared to tow trailers
max total weight 2000 kg and max vertical load 80 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
9
5
3
From manufacturer
1. Disassemble the bumper and its metal filling.
7
2. Take out the spare wheel.
3. Apply the main bar of the towbar (pos. 1) to the frame of the car
and through holes (pos. A) fix it loosely using bolts remaining
A
after metal fulfillment disassembly.
8
4. Apply brackets (pos. 4 and 5) as showed on the drawing and fix
them using bolts from towbar accessories.
5. Install the bumper.
6. Fix body of the automat and place tow-ball according to supplied
instruction. Note! Remember to place socket plate (pos. 3) as
shown on the drawing 1.
7. Tighten all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized service
station)
9. Complete paint layer damaged during installation.
2
After install the towbar you should get adequate note in registration
book (at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of
towbar must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M6 - 11 Nm M8 - 25 Nm
M12 - 87 Nm M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm