Preparing The Icemaker For Long Storage - Hoshizaki FM-1200ALKE Notice D'utilisation

ENGLISH
* The connections to the mains water supply
must be made in accordance with the countries'
current requirements of the Water Supply or
Water Fittings Regulations.
* I c e m a k i n g w a t e r m u s t b e p o t a b l e w a t e r.
Where scaling can be caused by water quality,
installation of an external filter or softener
is recommended. Contact your local water
treatment professional or Hoshizaki service
agent.
II. OPERATING INSTRUCTIONS
WARNING
1. This icemaker is designed to produce and
store edible ice. To keep the icemaker
hygienic:
* W a s h y o u r h a n d s b e f o r e r e m o v i n g
ice. Use the plastic scoop provided
(accessory).
* The storage bin is for ice use only. Do not
store anything else in the bin.
* Clean the storage bin before use (see "III.
1. CLEANING").
* Keep the scoop clean. Clean it by using a
neutral cleaner and rinse thoroughly.
* Close the door after removing ice to
prevent entrance of dirt, dust or insects
into the storage bin.
2. All parts are factory-adjusted. Improper
adjustments may result in failure.
3. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the compressor.
1. START UP
The installer will normally commission the icemaker
to start the automatic icemaking process. To
ensure continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is connected to the power supply.
To start the icemaking process, check the position
of the operation switch on the operation panel:
"OFF" position - Move it to the "ON" position.
"ON" position - Press the ice button.
Operation Panel
Ice Button Display
Maintenance Button
(service use only)
2. SHUT DOWN
Push the stop button on the operation panel.
The display will blink in the "STOP" mode for 15
minutes during the drain control operation and will
start to illumintate constantly at the end of drain
control.
3. PREPARING THE ICEMAKER FOR LONG
STORAGE
1) Follow the instructions in "2. SHUT DOWN".
2) Close the water supply line shut-off valve.
3) Open the drain valve.
4) Press the ice button on the operation panel to
drain the water circuit.
5) When no more water comes out of the drain
valve, press the stop button.
6) Move the operation switch to the "OFF" position,
and disconnect the power supply.
7) Close the drain valve.
8) Remove all ice from the storage bin, and clean
the bin.
4
Stop Button
Operation Switch
Fig. 1